How to adjust the strap a washing machine. The washing machine is not spinning, spinning too slow or is making a terrible shriek. What to do?
You will need
- Belts parts washer
- Old bath towels
- Adjustable wrenches
- Screwdriver Set
Instructions
- Unplug the washer and close the taps of water.
- Disconnect hoses from water and drain hose and pull the washer away from the wall, leaving you enough room to work behind the appliance.
- Which supports an old towel and kneel to absorb the water hoses losing.
- Remove the rear access panel.
- Locate the engine. The rubber belt goes around the pulley wheel attached to the motor.
- Press the belt. If you give more than 3/4 inch (1.90 cm), needs to be adjusted.
- Loosen the mounting nut for the engine and pushes the entire engine to increase belt tension.
- Hold the motor in place and adjust the mounting nut.
- Be sure not to tighten the belt too much or crack. You should be able to push and feel slightly sagging.
Tips and Warnings
- Replace the belt if it shows signs of wear.