You will need
- Door
- Parallel Studs
- Doorpost
- Level
- Wooden Shoes
- Interior Mouldings
- Hinges
- Gear Knob / ring
Instructions
- Measure your door. Please note the size before starting. Then add an inch or two on each side.
- Place two parallel nails in a wide space, and cut them up and add a cross bar to join them at the top end. Then, add a door jamb, a panel on the side of the hinge on the door to your art. With a few additional modifications have your input.
- Mark where the hinges go. Brand also where will the gear knob / ring on the other side of the entrance.
- Adjusts to probe. Use a level to check if the input is probed. If not, you use wood shims to place it correctly.
- Add trim inside the door frame. Get free edges so that the door to swing inward or outward.
- Hold the hinges on the right side of the frame and sets the target. Adjusts to probe again, if necessary.
- Engages the gear knob / ring. Make sure it is placed at the correct height, so that the shrink-ring snaps into the door frame (attached to frame) to close the door. Alternatively, if you have a latch mechanism, make sure that the door is not so dragging or hanging diagonal on the hinges.
Tips and Warnings
- There are several ways to adjust a door so that it is leveled correctly. A common way is to get thin material between the door jamb and the door frame to be located in the correct position.